Username:  Password:  
  / Register / Forgotten Login
Aquatics
Automotive
Caravans
Cleaners And Polishes
Construction
Engineering
Heavy Plant
Industrial
Marine and Diving
Motorcycles
Pool and Spas
Trucks
  • Testimonials
  • Repaplast Finish

Repaplast Finish

Repaplast Finish is a two-component epoxy plaster specially developed for plastics, which is extremely well suited for the fast repair of damage to plastic parts. The product forms an ideal transitional layer to the lacquer system. 

Repaplast Finish is ideal for filling and smoothing out scratches and irregularities in plastic parts. If cracks and holes in these parts are first repaired with Repaplast Grey/Black, Repaplast Finish can be used afterwards as a fine undercoat for the lacquering. The product can be sprayed over using almost any modern paint system. 

Repaplast Finish has a perfect adhesion to many plastics as well as lacquered and bare metal parts. In combination with the high temperature resistance and the high flexibility of the product, this property helps keeping the risk of island formation to a minimum. Due to its fast hardening, the product is ready to sand after only 20 minutes. 

Repaplast Finish contains no solvents, as a result of which it is not subject to shrinkage or cracking. Neither does the product contain isocyanates. 

Repaplast Finish is packed in a handy cartridge. Due to the 1:1 mixing ratio, it is very easy to dose and both products are consumed at an even rate. As a result, Repaplast Finish is both very easy to use and very economical. 
 
Surface preparation:
The surface must be clean, dry and free of grease. Clean surfaces with Innotec Repaplast Cleaner Antistatic and pre-treat with Innotec Repaplast Primer New Formula.

Method of use:
Put the accessory into the cartridge and place the cartridge in the Easy Grip Gun. Remove the screw cap, squeeze out the first 2 cm of product and discard it. Then squeeze out the necessary amount of product and mix until a homogeneous colour is obtained. Cover the surface to be repaired with Innotec Repaplast Primer New Formula and allow to evaporate for 10 minutes. Apply the mixture on the damaged spot and smooth with a spatula or a rubber spatula. After 20 minutes at 20°C, Repaplast Finish is perfectly sandable. For an OEM finish, always insulate the Repaplast Finish with a 1 or 2 component priming material. After use, close the cartridge by means of the plug and screw cap.

Properties:
- Two-component epoxy plaster. 
- Ideal transitional layer to the lacquer system. 
- Perfectly suitable for filling and smoothing out scratches and irregularities. 
- Can be perfectly sprayed/painted over. 
- Very flexible with an excellent adhesion to most plastics. 
- Fast curing, sandable after 20 minutes. 
- Perfectly sandable due to its fine and closed structure. 
- Handy cartridge allowing easy and exact dosing of the product.  
Repaplast Finish
  << 5 of 7 >>  
You need to be logged in to order this product.
BASKET: Total Items: 0
Total Price: £0.00 ex Vat